Burnet and the communities around it, Bertram, Meadowlakes, Marble Falls, Buchanan Dam, and Granite Shoals, are all within our service area. We handle the full range of residential and commercial heating and cooling work across this part of Burnet County: AC repair, furnace repair, heat pump service, ductwork, thermostats, indoor air quality, and full system replacement. Whether you own a home, manage a rental property, or run a small commercial space, we scope the job on the phone and confirm the price before anything is scheduled.
We cover this area for the same jobs we cover everywhere else we work.
Call (737) 345-9423 and tell us what the system is doing.
From there, we work through the diagnosis, the options, and the cost before anyone comes out. That is how it goes for a routine tune-up and for an emergency call alike. We are open every day from 6:00 AM to 10:00 PM.
A system's efficiency rating is calculated under controlled test conditions. What a property actually sees depends on factors the test does not account for: how well the ductwork seals, whether the equipment was sized correctly for the home, how the building holds or loses conditioned air, and whether the filter and coil are clean enough to let the system breathe.
An oversized unit short-cycles. It reaches the set temperature quickly, shuts off, and starts again before the air in the room has fully mixed. The result is uneven comfort and more wear on the compressor than a properly sized system would ever see. An undersized unit runs long and still cannot satisfy the thermostat on a hot afternoon.
Duct leaks are the other common gap. Conditioned air that escapes into an attic or crawlspace before it reaches the living area forces the system to work harder than the rating assumes. Sealing and repairing ductwork is often the most direct path to getting the performance the equipment was designed to deliver.
A seasonal maintenance visit checks the things that quietly erode real-world efficiency over time: coil condition, airflow through the evaporator and condenser, refrigerant charge, filter restriction, and thermostat calibration. Catching a dirty evaporator coil or a worn contactor in the spring costs far less than an emergency call in August when the same problem causes the system to fail.
We tell you if a permit is needed. We size the system to the home. We explain the options.
A full system replacement is not a single decision. It is a sequence of them. The first is whether replacement is actually the right move, which depends on the age and condition of the equipment, the cost and availability of parts, and what the repair history looks like. If those factors point toward replacement, the next question is what to replace it with.
Getting the sizing right matters more than the brand name on the unit. We calculate the load for the home before anything is ordered, because a system that is too large for the space will short-cycle and leave humidity behind even when it is cooling. A system that is too small will run constantly and still fall short on the hottest days. In this part of the region, where summers are long and humid, that calculation is not a formality.
The choice between a furnace-and-AC pairing and a heat pump is worth talking through. Heat pumps handle both heating and cooling from a single system, and the mild winters across this part of Texas mean the heating side rarely has to work at the edge of its capacity. For homes replacing aging equipment, a heat pump is often the more practical long-term fit.
A full replacement involves removing the old equipment, inspecting the ductwork before the new system is connected, and commissioning the new unit before we leave. How long a property is without conditioned air depends on the scope of the work and what the inspection turns up. We go through the timeline on the call when the job is scoped, so you know what to expect before the visit starts.
Pricing for heating and cooling work is not a single number because no two jobs are the same. A refrigerant leak diagnosis on an older AC is a different scope from a full system replacement, and a thermostat swap is different again from ductwork sealing across a whole house. What moves the price is the type of equipment involved, what has to be accessed to do the work, and whether the job is a repair or a replacement.
We go through all of that on the call. Describe what the system is doing and we can take it from there. By the end of that conversation, you have a price and an understanding of what it covers before anything is scheduled. That applies to straightforward repairs, to full replacements, and to commercial work on rooftop units and split systems.
If the technician finds something during the visit that changes the scope, that conversation happens before any additional work is done. You are not agreeing to an open number when you book. The range of work covered is explained on our page listing every HVAC service.
Call (737) 345-9423 for a quote.
Low airflow is usually a sign of one of three things: a filter that has not been changed in too long, a duct connection that has come loose or collapsed, or a blower that is not moving air the way it should. In older homes with additions or modified floor plans, the ductwork sometimes was never sized for the rooms it now has to reach. We check the full airflow path, not just the register that prompted the call.
A system that starts, runs for a few minutes, and shuts off before the house reaches temperature is not resting. It is failing to complete its cycle, and the cause can be anything from a refrigerant issue to a dirty coil to a thermostat that is reading incorrectly. Short-cycling accelerates wear on the compressor and leaves the home uncomfortable. It is worth diagnosing before it becomes a failure.
An AC that runs all day without pulling the indoor temperature down is usually losing refrigerant, dealing with a restricted coil, or working against an airflow problem that prevents the evaporator from absorbing heat properly. Running the system harder does not fix any of those. We trace the problem back to its source before quoting a repair.
A system that runs without stopping and still cannot reach the set temperature is either undersized for the load, losing conditioned air through duct leaks, or fighting a refrigerant or airflow problem. In humid conditions, a system that cannot keep up also stops removing moisture effectively, which makes the indoor air feel warmer than the thermostat reads.
Homes in this part of the region deal with humidity through the shoulder seasons, and a standard air conditioner only removes moisture when it is actively cooling. Whole-home dehumidification integrates with the air handler and ductwork to manage humidity independently of the cooling cycle. Filtration upgrades, UV air purifiers, and air scrubbers address dust, allergens, and stale air at the source. We install and service all of them as part of the same HVAC scope.
Homes that have never had central air, or that have additions and rooms the existing system does not reach, are candidates for new installation or a ductless mini-split. A mini-split handles a room or a zone without requiring new ductwork, which makes it practical for older homes and finished spaces that were never connected to the main system. We size and install both central systems and ductless configurations.
Heat pumps, furnaces and mini-splits all within scope.
We are open every day from 6:00 AM to 10:00 PM, and that covers both planned visits and last-minute calls. Seasonal maintenance, system replacements, and new installations are all scheduled on the call after the job is scoped. If you manage a rental property or a commercial space that has to stay occupied, we talk through the timing on the phone so the visit is arranged around what the property needs.
A system that has stopped working entirely is a different kind of call. We take no-heat and no-cool situations seriously throughout our operating hours. When you call, we go through the symptoms, scope what the visit will cover, and confirm the price before anyone comes out. The process is the same as any other call, just faster.
Give us a call and we'll get the comfort back.
Burnet is our primary area in this part of Burnet County, and we cover the surrounding communities on the same basis. That includes Bertram, Meadowlakes, Marble Falls, Buchanan Dam, and Granite Shoals. Homeowners, landlords, and small business owners across all of those areas call the same number and get the same process: scope the job on the call, confirm the price, schedule the visit.
If you are not sure whether your address falls within the area we cover, a quick call to (737) 345-9423 will answer that. Most of the surrounding county is within reach.
It does, and the regional climate plays into it. Gas furnaces and heat pumps both have a place in this part of Texas, but a heat pump handles both heating and cooling from a single system, which changes the calculation when an older furnace-and-AC pairing is both showing their age. We lay out the difference between continuing to repair and replacing the system on the call, so you have the full picture before you decide.
Zoning can be added to many existing systems, though the feasibility depends on the ductwork configuration and the equipment already in place. A ductless mini-split is a common way to add a zone to a space that the existing system does not serve well. We scope what is possible based on the layout and equipment when you call.
A repair that does not last usually means the root cause was not fully addressed, or that a second component was already failing when the first repair was done. Refrigerant that was recharged without finding and fixing the leak will simply escape again. We start with the diagnostic rather than assuming the previous assessment was complete.
Older homes and properties with additions are the most common cases. A room that was added after the original system was installed often sits at the end of a duct run that was never sized to reach it properly, and connections in attic spaces can loosen or deteriorate over time. We look at the full duct system when airflow or uneven temperatures are part of the complaint, not just the room that prompted the call.
Gradual efficiency loss is most often a combination of factors building up over time: a coil that has accumulated dust and debris, a refrigerant charge that has slowly dropped, duct connections that have loosened, and a filter that has not been changed as often as it should. A maintenance visit addresses most of those at once.
The most common mistake is waiting until the system has completely failed before calling. A system that is struggling, running longer than usual, or producing uneven temperatures is already telling you something is wrong. Calling while it is still running gives us more to work with diagnostically and usually results in a less expensive fix.
A clear path to the air handler, the filter access panel, and any ductwork connections that need to be inspected makes the visit go more smoothly. Stored items in mechanical rooms, closets, or attic access points that block the equipment are worth moving before the technician arrives. We will let you know on the call if there is anything specific to prepare.
Whether it is an AC that stopped cooling, a furnace that will not ignite, a heat pump running constantly without hitting temperature, or a full system that has reached the end of its useful life, call (737) 345-9423 and we will work through it with you. We are open every day from 6:00 AM to 10:00 PM.
Schedule it. We fix it. You're comfortable.
There is more on our complete coverage area. Neighboring areas in range: Leander, Georgetown, Jarrell.
From a refrigerant leak on a ten-year-old AC to a full heat pump installation, we handle the complete range of heating and cooling work for homes and businesses in Burnet and across Burnet County. The table below covers every service we offer, who it fits, and what is worth knowing before you call. Price is confirmed on the phone before anything is scheduled, and the job is scoped before anyone comes out.
| HVAC Service | What the Service Includes | When You Need It | Things to Know |
|---|---|---|---|
| Heat Pump Repair & Service | Reversing valve diagnosis, Refrigerant charge check, Defrost cycle inspection, Heating and cooling mode testing | Homes running a heat pump year-round in the Central Texas climate | Heat pumps in this area run both seasons, so problems can surface in spring or fall when the system switches modes. |
| Thermostat & Smart-Control Installation | Programmable thermostat installation, Smart thermostat setup and configuration, Zoning system controls | Homeowners looking to reduce energy use or gain better control over comfort in different parts of the home | A thermostat that is not reading temperature correctly can cause a system to short-cycle or run longer than it should, which shows up on the energy bill. |
| Full System Installation & Replacement | System sizing for the home, Indoor and outdoor unit replacement, Permit coordination where required, Commissioning and testing | Homes with aging equipment, repeated repair costs, or a refrigerant type that is no longer in production | An oversized unit short-cycles and leaves humidity behind. We size the system to the home before any equipment is quoted. |
Call (737) 345-9423 and describe what the system is doing. We will talk through it with you, confirm the price, and get the work scheduled.
(737) 345-9423